Geology in the Parks home NPS home USGS home Black National Park Service/US Geological Survey

Death Valley field trip button Death Valley geology field trip

Death Valley Dunes

Death Valley Dunes
Death Valley Dunes. Photo from NPS archives.

Sinuous sculptures of sand

spacer image Death Valley's most accessible sand dunes are just a few miles from Stovepipe Wells. Tucked into Mesquite Flat in the north end of the park, these dunes are nearly surrounded by mountains on all sides. The primary source of the dune sands is probably the Cottonwood Mountains which lie to the north and northwest. The tiny grains of quartz and feldspar that form the sinuous sculptures that make up this dune field began as much larger pieces of solid rock.

Breaking down bedrock

spacer image Even in this parched climate, the effects of weathering take their toll on rock. High in the mountains, which receive quite a bit more moisture than the valley floor, bedrock is broken down into blocks. Flash floods, speeding storm waters that rush down from bare mountain slopes during intense desert storms, grind the rock to smaller pieces as it hurtles toward the valley floor. Eventually large blocks may be jostled around enough to be broken into sand-sized grains.
spacer image Sand and other sediment usually ends up deposited on alluvial fans or on the valley floor. In Death Valley's climate, it doesn't take long for the sediment to dry out and become exposed to the prevailing northwest winds.
Dune formation
Migrating sand grains may be suspended in the air (suspension), bounced along (saltation), or nudged along by impact from bouncing, saltating grains(impact creep).

Sand on the move

spacer image All it takes is a bit of breeze (16 kilometers/hour or 10 miles/hour) to whisk fine sand into motion. The grains may be suspended in the air, bounce along, or nudged along by impacts from bouncing grains, depending upon the grain size and wind strength. Almost all blowing sand remains within a meter of the surface as it migrates.
Ripplemarks on Death Valley Dunes
Ripplemarks on Death Valley Dunes. Photo from NPS archives.

Ripples and dunes

spacer image Once sand begins to pile up, ripples and dunes can form. Wind continues to move sand up to the top of the pile until the pile is so steep that it collapses under its own weight. The collapsing sand comes to rest when it reaches just the right steepness to keep the dune stable. This angle, usually about 30-34°, is called the angle of repose. Every pile of loose particles has a unique angle of repose, depending upon the properties of the material it’s made of.

Dune formation diagram

close up of Jurassic Aztec Sandstone crossbedding
spacer image The repeating cycle of sand inching up the windward side to the dune crest, then slipping down the dune’s slip face allows the dune to inch forward, migrating in the direction the wind blows. As you might guess, all of this climbing then slipping leaves its mark on the internal structure of the dune. The image on the right shows sand dune structure preserved in the Jurassic Aztec Sandstone at Lake Mead National Recreation Area. The sloping lines or laminations you see are the preserved slip faces of a migrating sand dune.

Death Valley Dunes in time
geologic time scale
pebble
On to next stop If you're going... Death Valley Dunes image gallery
| Death Valley geology | Death Valley National Park | Geology field trip |
| Death Valley time| Geologist's page | Image gallery |

horizontal bar
| USGS Geology in the Parks home | NPS Park Geology Tour home |

This site is a cooperative endeavor of the
US Geological Survey Western Earth Surface Processes Team
and the National Park Service.
Please share your comments and suggestions with us!
parkgeology@den.nps.gov

http://www.nature.nps.gov/grd/usgsnps/deva/ftdune1.html
This page was last updated on 6/30/00
preload image